Besides the title sounding like the most racist shit ever.
I am about to buy another Clutch Slave Cylinder. I am willing to spend roughly 75.00 on one. i dont need a high end one because i will use it less than 9 months. Then i will have the car sitting in the garage again
Right now i am looking at this Duralast from Autozone Duralast Clutch Slave Cyl
Also i am looking at this Remote bleeder
But then i also need a clutch hydraulic linee. Heres my two options: Buy a new pre-made line or Buy the materials( Line, Fittings, Crimp tools) and make my own.
Make my own
Steel Braided Line
But what AN4 crimps do i need? and what tool to crimp them?
Sizing Fitting Thread
Buy a pre-made one:
Kind of a rip off. I could buy a whole slave, master, and line for around 200.00