Camaro Zone - Camaro Forums and News

Camaro Zone - Camaro Forums and News (https://www.camarozone.com/forum/)
-   4th Gen (1998-02) Camaro and Firebird Tech (https://www.camarozone.com/forum/f18/)
-   -   1998 Camaro- V6 Flooding Problem, Kind Of (https://www.camarozone.com/forum/f18/1998-camaro-v6-flooding-problem-kind-196473/)

Ratchet 08-06-2019 11:16 AM

1 Attachment(s)
Hi everyone... I need some troubleshooting advice on this one...

I have a 1998 Camaro, 3.8 V6 automatic with 173k. No check engine light or codes. The car recently developed a kind of flooding issue that resulted in hard starts after sitting for a few hours and fuel getting in the oil. The analysis report stated 6.6% when I had it tested at 950 miles on the oil.

I replaced all 6 injectors, assuming at least one was leaking. When that didn’t fix it, I found that the fuel rail wasn’t holding pressure and that the vacuum line to the fuel pressure regulator smelled like gas when disconnected (no liquid fuel noticed). For good measure, I changed the fuel pressure regulator too, since I assumed the fuel smell indicated a leaky diaphragm. That didn’t solve the problem either.

First thing in the morning, the car starts fine. When I get in the car at lunchtime, 4-5 hours later, it cranks but doesn’t want to start unless I press the throttle while cranking. It doesn’t have to be more than 1/3 throttle to start it, but it fires right up when the pedal is pressed. Once running, there are no drivability issues. It never stalls, hesitates, or misfires. It just seems to either be leaking gas into the intake after shutting off the ignition or dumping too much fuel while running. It does it every time I drive it and let it sit for less than 6-8+ hours.

I haven’t checked fuel pressure because A) all or most pressure bleeds off after about an hour, and B) it runs and drives fine once it’s started.

But again, no codes are showing up. I tuned it up last year with AC Delco plugs and wires, but not the coils. I haven’t pulled any plugs yet (cuz they’re so much fun on this engine), but I would think that it would run rough or throw a code if one or more cylinders weren’t firing properly.

I’ve checked various threads on different sites and found similar issues but not quite what my car is doing. Do you guys have any ideas?


PS- I also replaced the IAC valve...no change. It just seems to be getting too much gas or leaking it in the intake. Fuel economy has predictably deteriorated too.

NavyVet 08-08-2019 01:02 PM

About the only thing I can think of is a possibly bad Mass Air Flow sensor. ( MAF ) But it should throw a code I would think. Also the hard starting problem is most likely because the check valve in the fuel pump has failed allowing the pressure to bleed off. Therefore the fuel rail is basically empty when to crank the engine. Try this, turn the key to Run only not Start, and wait 3 seconds, turn it off, then back on and try to start it.


All times are GMT -4. The time now is 08:52 AM.

Powered by vBulletin®
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright © CamaroZone.com