Camaro Zone - Camaro Forums and News - Conversation Between 96firephoenix and BuMouTLaW

Go Back   Camaro Zone - Camaro Forums and News > 96firephoenix

Conversation Between 96firephoenix and BuMouTLaW
Showing Visitor Messages 1 to 9 of 9
  1. 96firephoenix
    04-22-2011 04:34 PM - permalink
    adhesive the middle and the corners, and smooth them all down. you can get away with doing the whole thing in one go, but you need to work from the middle outward
  2. BuMouTLaW
    04-22-2011 04:27 PM - permalink
    So you start in the middle, adhesive the middle up, when that drys, glue the corners down then keep moving up/down?
  3. 96firephoenix
    04-22-2011 04:25 PM - permalink
    you have to start in the middle and then work the curves in as you go out. that distorts the rest of the piece a little bit, but it will work out
  4. BuMouTLaW
    04-22-2011 04:18 PM - permalink
    I mean, the curve areas. It's impossible to fold those without pressure tearing at another side?
  5. 96firephoenix
    04-22-2011 04:11 PM - permalink
    you have to fold the piece in half with the good side inside and then set it down. but yea, you kinda gotta not spray the whole thing at once. wait for it to dry and start over.
  6. BuMouTLaW
    04-22-2011 04:06 PM - permalink
    Dude, how did you tuck in all the curved parts? My dad, being the genious he is, worked on it when I went out the house and sprayed up the whole thing EXCEPT the ****ing corners...
  7. 96firephoenix
    04-18-2011 01:14 AM - permalink
    I took the visors out completely... none of the places I found matched the visors, and I never used them.

    again, I can't stress enough the line in the write up about starting in the middle if you have a T-top car. I made the mistake of working from the front to the back and the inward swells of the ttops were dang near impossible and looked like crap.
  8. BuMouTLaW
    04-17-2011 05:32 PM - permalink
    So I just picked up the supplies to replace my headliner like in your write-up. Hopefully sometime this week I can try this out....better work. lol. Did you just leave your visors the same and all that?
  9. BuMouTLaW
    01-09-2011 11:35 PM - permalink
    "2 handed facepalm... is it greater than or equal to a two person facepalm?"

All times are GMT -4. The time now is 12:51 PM.
Powered by vBulletin®
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright © is in no way associated with or endorsed by General Motors or Chevrolet.