Camaro Zone - Camaro Forums and News - Search Results

Go Back   Camaro Zone - Camaro Forums and News > Search Forums

Showing results 1 to 25 of 500
Search took 0.39 seconds.
Search: Posts Made By: 96firephoenix
Forum: 4th Gen (1998-02) Camaro and Firebird Tech 11-28-2018, 11:06 AM
Replies: 1
Views: 213
Posted By 96firephoenix
One of the guys here did it on his 99, but he...

One of the guys here did it on his 99, but he acquired a donor Camaro SS and used the fuel lines from the LS F-body.

There's something to do with the v6 having a return and the v8 doesn't?
...
Forum: Camaro & Firebird News 10-24-2018, 09:42 AM
Replies: 2
Views: 350
Posted By 96firephoenix
your battery is not fully charged.

your battery is not fully charged.
Forum: V6 Camaro and Firebird Tech 10-02-2018, 03:54 PM
Replies: 1
Views: 272
Posted By 96firephoenix
check for a spark plug wire flopping onto the...

check for a spark plug wire flopping onto the exhaust. I had to replace my No.1 plug wire after it popped out of the little holder.

It was still running pretty well when this happened , but the...
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 09-05-2018, 11:19 AM
Replies: 2
Views: 474
Posted By 96firephoenix
Good find, but sad that they have to crush the...

Good find, but sad that they have to crush the shell. Make sure you unbolt everything off the body to sell or keep as spares before you send the frame to be crushed, particularly the interior.
...
Forum: 1st Gen & 2nd Gen (1967-81) Tech 08-22-2018, 11:14 AM
Replies: 3
Views: 362
Posted By 96firephoenix
Iron Eagle – Dart...

Iron Eagle – Dart (http://dartheads.com/product-category/small-block-chevy/heads-small-block-chevy/iron-eagle-heads-small-block-chevy/)

Maybe give the company a call.
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 08-17-2018, 03:17 PM
Replies: 4
Views: 339
Posted By 96firephoenix
I would think that the non-cruise stalk would...

I would think that the non-cruise stalk would have a different connector, wouldn't it?
Forum: General Discussion 08-17-2018, 03:16 PM
Replies: 4
Views: 372
Posted By 96firephoenix
The 6.2 LT4...

The 6.2 LT4...
Forum: General Discussion 08-16-2018, 02:27 PM
Replies: 1
Views: 263
Posted By 96firephoenix
Those stay on the door on the firebird, I'd...

Those stay on the door on the firebird, I'd assume the camaro is the same.
Forum: General Discussion 08-16-2018, 02:13 PM
Replies: 4
Views: 372
Posted By 96firephoenix
the V8 was the LT1 engine, but the 93-97 body...

the V8 was the LT1 engine, but the 93-97 body style is referred to as the "LT1" body, and the 98-02 is the "LS1" body; after the v8s that came in them.

The 3.8 was the L36.

The 5.7 LT4 was...
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 08-16-2018, 02:01 PM
Replies: 11
Views: 921
Posted By 96firephoenix
4th gen has the stepper motor type gauges, not...

4th gen has the stepper motor type gauges, not the mechanical gauges.

I think 93/94 might have had a speedo cable, but I"m not sure.
Forum: Introductions 08-16-2018, 01:58 PM
Replies: 1
Views: 241
Posted By 96firephoenix
Hate to break it to you, but this forum is pretty...

Hate to break it to you, but this forum is pretty well and dead.

That camaro looks pretty nice though!
Forum: 4th Gen (1998-02) Camaro and Firebird Tech 08-02-2018, 02:10 PM
Replies: 2
Views: 305
Posted By 96firephoenix
The Poly motor mounts will pass a lot more...

The Poly motor mounts will pass a lot more vibration to the chassis than the stock. I'd really discourage the solid motor mounts unless this is a dedicated race car.
Forum: V6 Camaro and Firebird Tech 07-31-2018, 11:32 AM
Replies: 3
Views: 582
Posted By 96firephoenix
dude. You are trying to put an OBD1 engine into...

dude. You are trying to put an OBD1 engine into an OBD2 Chassis. On top of that, the 02 v6 is a drive-by-wire throttle, so there's no throttle cable on the gas pedal, just a wiring harness.

Hate...
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 07-25-2018, 12:51 PM
Replies: 9
Views: 770
Posted By 96firephoenix
I'd say pull the bracket off the block and see if...

I'd say pull the bracket off the block and see if it's easier on the bench than in the car.
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 07-24-2018, 11:28 AM
Replies: 9
Views: 770
Posted By 96firephoenix
Looks like the bracket comes with the new part....

Looks like the bracket comes with the new part. Should just be the one bolt, a vacuum line, and an electrical connector.

https://www.rockauto.com/info/154/VS27photo%20primary__ra_p.jpg
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 07-10-2018, 11:21 AM
Replies: 9
Views: 770
Posted By 96firephoenix
Fold down the rear seat. Look closely at the...

Fold down the rear seat. Look closely at the carpet behind them for a crescent shaped perforation right next to the latch post for the rear seat. Use a utility knife to cut the carpet along the...
Forum: 4th Gen (1998-02) Camaro and Firebird Tech 07-10-2018, 11:01 AM
Replies: 3
Views: 551
Posted By 96firephoenix
Coil packs would be the first place to start, as...

Coil packs would be the first place to start, as they have a higher failure rate than the ICM.

Before you replace anything, you should take the coil packs off and clean up any corroded terminals,...
Forum: 4th Gen (1998-02) Camaro and Firebird Tech 06-26-2018, 10:43 AM
Replies: 3
Views: 700
Posted By 96firephoenix
https://www.camarozone.com/forum/f20/write-up-how-...

https://www.camarozone.com/forum/f20/write-up-how-make-your-own-passenger-window-fix-23707/

it's driver's window for you. Considering that RHD was an afterthought in the design of these cars, I'd...
Forum: Members Camaros and Firebirds 06-25-2018, 05:05 PM
Replies: 4
Views: 743
Posted By 96firephoenix
you probably have a leak in the vacuum lines....

you probably have a leak in the vacuum lines. There's a T fitting on the passenger side of the firewall that is prone to breaking. I had to fix it in both of my 3.8 cars.

make sure you have good...
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 06-25-2018, 05:03 PM
Replies: 1
Views: 487
Posted By 96firephoenix
I'm pretty sure 3.1 and 3.8 bolt patterns don't...

I'm pretty sure 3.1 and 3.8 bolt patterns don't line up. 3.1 and 3.4 would, but the 3.8 was based on completely different architecture. Obviously if you've confirmed this on the actual parts, ignore...
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 06-19-2018, 10:08 AM
Replies: 4
Views: 684
Posted By 96firephoenix
it will if you have leftover pushrods when you're...

it will if you have leftover pushrods when you're done. ;)

it almost sounds like you've got a valve issue. What did your compression test show?
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 06-12-2018, 11:18 AM
Replies: 9
Views: 770
Posted By 96firephoenix
check your hi-mount bulbs in the wing tail-light....

check your hi-mount bulbs in the wing tail-light. The "brake" light on the dash will light for several reasons, and I think a brake light fault is the only one you haven't checked.

Could also be...
Forum: 4th Gen (1993-97) Camaro and Firebird Tech 06-11-2018, 02:17 PM
Replies: 9
Views: 770
Posted By 96firephoenix
the PCM needs to be reprogrammed for the speedo. ...

the PCM needs to be reprogrammed for the speedo.

The EGR should just be a bung on the exhaust, a bung on the intake, and then a couple mounting bolts.
Forum: 4th Gen (1998-02) Camaro and Firebird Tech 06-07-2018, 09:59 AM
Replies: 2
Views: 655
Posted By 96firephoenix
it looks like a heat sheild that goes on the...

it looks like a heat sheild that goes on the passenger front floorboard on the catalytic converter hump.

I'm not certain of that though.

You could try finding spaces that this piece fits...
Forum: General Discussion 06-07-2018, 09:55 AM
Replies: 2
Views: 376
Posted By 96firephoenix
There should be a button for the hatch, down...

There should be a button for the hatch, down below the headlight switch on the knee bolster.

The RS model should also be set up for remote entry. This video says you have to pull the radio fuse,...
Showing results 1 to 25 of 500

 
Forum Jump

Powered by vBadvanced CMPS v3.2.3


All times are GMT -4. The time now is 09:30 PM.
Powered by vBulletin®
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright © CamaroZone.com

CamaroZone.com is in no way associated with or endorsed by General Motors or Chevrolet.