Camaro Zone Forums banner
drive shaft
1-3 of 3 Results
  1. 4th Gen (1993-97) Camaro and Firebird Tech
    175,000 miles, I guess it's time for the drivetrain to start showing its age. I was driving home from work today, stopped at two places, last of which being just around the corner from my house. I pulled out of the parking lot "with spirit" and started hearing this clunking sound. It was...
  2. 4th Gen (1993-97) Camaro and Firebird Tech
    long time no post... so ive been hearing alot of noise coming from under so i checked it out today. Center Support Bearing is all torn up. U joints seem good. Ive been looking around and people say to replace the 2 piece driveshaft with a 1 piece aluminum one. I wanted to confirm this since...
  3. 4th Gen (1998-02) Camaro and Firebird Tech
    My drive shaft (cv joint/spline)had failed. I was vary lucky to find a local drive train shop that made a straight drive shaft. It's 44 1/2 in. from trans rear seal to center of u-joint. after install and replacing pinion seal. I'm happy with the results,much better response and feel than the...
1-3 of 3 Results
Top