Camaro Zone Forums banner

steering

  1. 4th Gen (1993-97) Camaro and Firebird Tech
    Took my 95 in to get an alignment today. Back in December I hit a curb pretty badly, and as a result had to replace my passenger side front upper & lower control arms. I discovered my outer tie rod end on that side was completely shot, and had virtually no resistance, which probably contributed...
  2. 4th Gen (1998-02) Camaro and Firebird Tech
    I just replaced a leaky steering rack on my 2000 Camaro conv SS. Now the new rack (from Rock Auto) binds and snaps with a clonk when the wheels are max to the right. When I lift the front and turn the wheels by hand is stops almost at the end and when I put some extra force it "jumps" to the end...
  3. 5th Gen (2010+) Camaro Tech
    I have had my new zl1 for a few months and I love it, although I am slightly concerned with a certain pulling that occurs with the electric power steering at low speeds. While accelerating at low speeds it seems that there is a slight loss of control in the steering where the car pulls to either...
  4. General Camaro & Firebird Tech
    When I bought my car it had 215/65/16 winter ties on it. Drove perfectly down the road. I just put on some 255/50zr16's and now it follows every grove on the road. If its not a perfect road the front just jerks into every grove. I've checked the front end and everything seems good and tight. No...
  5. General Camaro & Firebird Tech
    Here is a guide for 4th gens on what you need to convert your steering wheel from one with no headunit controls to one that has built-in headunit controls. My car didn't have steering wheel radio controls since it was ordered with the base sound system. I wanted them. This is what I had to do...
  6. 1st Gen & 2nd Gen (1967-81) Tech
    I am wondering if anyone can help. I want to upgrade the steering on my 69 camaro. I want to autocross it in the future. Should I upgrade my steering to a full rack and pinion with power or no power steering, or should I buy an aftermarket manual steering box with a ratio of 16:1? any advice ??
Top